When lubricating small gearbox parts in the automotive sector special requirements arise with regard to repeatability, positioning accuracy and dosing speed.
Spray lances are often used for the lubrication of components in the drive train of commercial vehicles in order to achieve the largest possible area of application.
When applying bonding agents/primers using the classic methods of sponge, spray or time/pressure contact dispensing, the special requirements regarding accuracy of the dosing volume and positioning can lead to problems time and again.
Rotor assemblies of electric motors are provided with a synthetic fibre bandage, unless a cage-like construction has been selected.
During the encapsulation of electronic components, depending on the type of substrate, a suitable material is dispensed over e.g. IC and wires to protect them against environmental influences and mechanical stress.
In the semiconductor industry integrated circuits (ICs) are connected by wire bonding to the external electrical connections of the component.
During the manufacturing process of aluminium heat exchangers of any kind surfaces are pretreated with fluxes.
Underfill is the filling of the cavities between the terminals of the semiconductor chip and the circuit carrier with a correspondingly elastic and temperature-resistant encapsulation material.
When joining permanent magnets within DC electric motors conventional joints are increasingly being replaced by modern adhesive joints.
The perfecdos micro dispensing valve PDos X1 sets a new benchmark in jetting extremely small dots of SMD adhesive!
The contactless application of TIM (Thermal Interface Materials) with a jet valve from perfecdos offers "valuable" advantages compared to contact application with a progressive cavity pump.